Forum Post: bq77PL900 EVSW Source Code
Is the source code for bq77PL900 EVSW (http://www.ti.com/product/bq77pl900) available?
View ArticleForum Post: source code for bq2416xEVM software?
Is the source code for bq2416xEVM software http://www.ti.com/tool/bq24160evm-721?DCMP=hpa_pmp_mr&HQS=bq24160EVM-pr) available?
View ArticleForum Post: RE: EV2400 and bqEVSW------
Shirish,Thanks a lot for your assistance.That is what I did in the first place, - downloaded the EV2400 Support Components_ 20110524.exe but when I should run the EVSW (09.99) after running this sw i...
View ArticleForum Post: RE: bq20z75 V1.81 - Control of DSG in Battery Status during UN...
Dear all, I might have made my question to complicated - to make it more simple....If during UN Thermal testing the SOT Chg temperature is exceeded with more than 10 deg C but no chg current is flowing...
View ArticleForum Post: RE: Maximum Charging current of BQ24650 .
Hi,i have some questions and need your helping.First,the working current of bq24650 EVM circuit is about 10mA ,when I use IRL7833 to replace SI7288 ,is up to 40mA,that is why? IRL7833 feature...
View ArticleForum Post: Battery pack Production flow With bq20z75........
Dear all, As a part of the Production flow after calibration but before our BMS-module is attached to the cells we perform function testing (charge - discharge etc) to verify that the bq20x75 and the...
View ArticleForum Post: bq27530
HiI am using bq27530evl + ev2300.I am using gas gauge evaluation software but cant understand how to use it.I have a battery and load that are connected as shown in the documentation.I did the the...
View ArticleForum Post: RE: disturbance on BQ24650
Please attach a PDF schematic. The one copied above has poor resolution and I can't read it.It would be helpful to have waveforms of all pins of the IC and at least two waveforms per plot so I can see...
View ArticleForum Post: RE: PassedCharge register
Isak,The device will reset Passed Charge when it sets a new DOD point. The OCVTAKEN flag should get set at that point.Tom
View ArticleForum Post: BQ24103A, Datasheet Issue, What is minimum required input bias...
I am using the BQ24103A lithium ion battery charger IC. In my design I wish to inactivate the temperature sense circuit functions connected to the TS-pin. I have connected the TS pin by resistive...
View ArticleForum Post: bq77PL900 programming adapter
Does it need EV2300 board, or can the TI USB-GPIO be used as well?We do have the USB-GPIO adapter, driver seems to be working, however bq77PL900 demo software does not recognize it.Also I am having a...
View ArticleForum Post: RE: Calibration Accuracy
Hi Onyx,Thanks for your answer, I will search for very accurate multimeter then. Do you have tips for me about some good and accurate multimeters ?ThanksAlex
View ArticleForum Post: TPS65950 Backup Battery
We have developed a commercial product that utilizes the TPS65950 for managing the backup battery of the real time clock. We use a MS (Manganese Silicon) lithium rechargeable battery (Battery...
View ArticleForum Post: RE: AFE SC Chg Cfg Verification Testing
Thanks for the response. The problem we are getting is that the device is not disabling the FETs. Consequently the Charger voltage is collapsing.We have concluded the discharge verification tests at...
View ArticleForum Post: RE: Missing definition for function WriteSMBusInteger in document...
The WriteSMBusWord() function is the same as WriteSMBusInteger()bq80xrw.ocx uses the name WriteSMBusWord()
View ArticleForum Post: RE: BQ24250 Evaluation module
Hi,It is a 2.2-ohm high power resistor with head sink. It can sinks up to 4A/4.4V. On side is connected to BAT (As battery terminals) and the other to another power supply. The diode is used to protect...
View ArticleForum Post: RE: Battery pack Production flow With bq20z75........
Hi Onyx,Thank you for all valuable information. We will follow your advice.Again, thank you for the support. The forum play an important role in my opinion. Best regardsKjell
View ArticleForum Post: RE: bq20z75 V1.81 - Control of DSG in Battery Status during UN...
Hi Onyx,Thanks again for your support. I feel comfortable with your answer.Your explanation tells me that what I have observed has a rationalexplanation and will not be something that varies from time...
View ArticleForum Post: RE: Impedance Track Battery Charging Question
Oh my, looks like I need another cup of coffee today! Fixed that bit as well.
View Article
