Forum Post: BQ24232H can recharge Li-Polymer cell?
Hi,on the product page of BQ24232H (http://www.ti.com/product/bq24232h) I have read that the BQ24232H can also recharge Li-Polymer cell, but in the datasheet I haven't found any reference to that.Can...
View ArticleForum Post: RE: Using the EV2400 with a bq27530
You can use GaugeStudio to work with your bq27530 (SLUC424).
View ArticleForum Post: RE: BQ24278 CHG LED Odd Behavior
Hi Jeff,Thanks so much for your replay. With this device there is NO explicit Termination Enable/Disable pin. Termination condition is automatically detected.This is only 1 case where I see CHG pin...
View ArticleForum Post: RE: BQ24232H can recharge Li-Polymer cell?
Hi Jeff,Thank you for your answer.Is 4.35V referred to fully charge voltage?Could you please suggest me a "Battery Charger and Power-Path Management IC" for li-poly cell:Nominal voltage: 3.7 VFully...
View ArticleForum Post: RE: Learning cycle for BQ27200DRKR to know actual battery capacity
Moving this to the Battery Management - Gas Gauge Forum
View ArticleForum Post: BQ27510 device is not come out from the ROM mode
Hi SIr / Madam ,This is vengad here from Avnet , one of my customer has completed the BQ27510 Fuel gauge proto board for Medical applcaition .They need to do command line approach to program the fuel...
View ArticleForum Post: Using of bq80xRW.ocx with EV2400
Can we use bq80xRW.ocx to communicate through the EV2400 as with EV2300?The Write and Read command were bq80xRW1.WriteOneWire(1, &H61, 0) and bq80xRW1.ReadOneWire(1, &H14, nWord) when we use...
View ArticleForum Post: RE: bq34z110 Chemistry ID for G & Yu EB-100 Lead Acid battery.
Watanabe-san,The lab will need the voltage, current and capacity information found on any battery datasheet. Also, provide the submission form that provided in the email. Tom
View ArticleForum Post: RE: BQ76PL536A-Q1 Problem with the cell voltage measurement...
Hello,we have now discovered another Problem but we don´t know if theres a correlation between this new one and the one described above and in our other post...
View ArticleForum Post: RE: bq76pl536
Keyvan, I am moving you to the battery management forum for better support.
View ArticleForum Post: RE: BQ24278 CHG LED Odd Behavior
Thanks Jeff.Unfortunately my CPU is powered by the SYS pin and I cannot toggle CD but I can toggle CE. I tried this but it did not resolve my power up CHG=LOW-Z with NO battery connected.Any other...
View ArticleForum Post: RE: BQ34Z100 Learning cycle
Jake,I reviewed your log data and setup file. Your procedure looks okay, but I see a few things that could affect the results. You have a 2-cell configuration and the Number of Series Cell parameter is...
View ArticleClik here to view.
Forum Post: RE: BQ24650evm-639 charge current
Hello Hyeon-Bo,The fact that it is working at one voltage input and not the other I am thinking it might be related to the MPPT on the input. What is the voltage at the input to the EVM when you...
View ArticleForum Post: RE: Bq34Z110 comunication
The device uses a standard SMBus communications interface. If you have a translator, then you could probably get it to bridge to WiFi.
View ArticleClik here to view.
Forum Post: RE: BQ24295 PMID pin
Hello Natallia,Are you asking if RBFET(Q1) & HSFET)Q2) will be opened when the boost converter is disabled?The RBFET is used to isolate the INPUT and PMID to prevent reverse conduction when the...
View ArticleForum Post: RE: DV2000S1 Evaluation Limitations
Hello Josh,There are a number of very helpful sites that can be used to help establish a wide and knowledge base about batteries and to dig deeper into specific chemistries and scenarios.I would...
View ArticleForum Post: bq24040 - The function of nCHG-terminal
Hello,When I applied the voltage "out of the charging range (4.0V - 4.4V)" to IN-terminal,the charging does not occur, but nCHG-terminal becomes LowIs this function correct?Regards,Daisuke
View ArticleForum Post: RE: BQ24232H can recharge Li-Polymer cell?
Hi Jeff,Thank you for your support.Regards
View ArticleForum Post: RE: bq20z75-v180 update status 0x0A
Thank you Sir.Can you suggest the newer devices similar to bq20z65.
View ArticleForum Post: BQ25570 External supply through Mini PCIexpress
Hello,I am trying to build a sensor board that is going to be powered by a solar cell Li-ion ( 4.2 V) battery with the BQ25570. The board is going to be build on a half mini PCIexpress board and will...
View Article
